CJ86 EMC Armored Marine Power and Control Cable - Marine Power Cable - Hi-sea

CJ86 EMC Armored Marine Power and Control Cable

CJ86 EMC armored Marine Power and Control Cable

CJ86 EMC armored Marine Power and Control Cable


 This product is used in ships,petrol platforms and offshore buildings for power,light and control systems,usually used for fixed installation in most areas and open deck in ships.Design to meet requirements for improved EMC screening properties.If the cable is exposed to direct sun light protective covering or cable with black outer sheath is recommended. 



 Stranded copper wire 1.0mm² to 10mm² Class 2 

 Stranded copper wire 16mm² to 240mm² Class 5(Flexible) 

2.Insulation XLPE 

3.Bedding Separate tape 

4.Screen Copper tape,covering 100% 

5.Amore Copper wire braided,covering 90% 

6.Sheath Thermoplastic Polyolefine(SHF1),On requesting Thermosetting Polyolefine(SHF2) standard colour black, other colours on request.

Applied Standards

Design IEC 60092-353
Conductor IEC 60228 Class 2,Class 5
Insulation IEC 60092-351
Sheath IEC 60092-359
Flame-retardant IEC 60332-1-2 -test for single insulated wire and cable IEC 60332-3-22 -test for bunched wires and cables, category A
Halogen-free IEC 60754 series
Smoke emission IEC 61034 series
Transfer Impedance IEC 61196-1 (typical value 26dB over 1mΩ/m at 100MHz [20mΩ/m])

Service Conditions 

1.Rated Voltage:AC 0,6/1kV (1,2kV) DC 0,9/1,5kV (if voltage to earth does not exceed 0,9kV) 

2.long time working temperature 90℃ 

3.Minimum recommended installation temperature -15 °C 

   Lowest operation temperature -40 °C 

4.flexible cables for mobile devices,the other cables are fixed laying cable bending radius while laying is as below

Cable Structure Cable Outer Diameter Minimum Bending Radius
Metal Braided Armored 6D
Non Armored D≤25 4D
D>25 6D

Contact with us now

Our mail: hs@cqhisea.com